Wavecom G900 Manual de usuario descargar pdf (Pagina 49)

Wavecom GSM Modem

This confidential document is the property of WAVECOM and may not be copied or circulated without permission

Application to GSM AT&C0 DCD always on

GSM to application OK command valid

Application to GSM AT&C1 DCD matches state of the remote modem's

data carrier

GSM to application OK command valid

7.11. Set DTR signal &D

This commands controls the Data Terminal Ready (DTR) signal.

Application to GSM AT&D0 the DTR signal is ignored

GSM to application OK command valid

Application to GSM AT&D1 Modem switches from data to command mode

when DTR switches from on to OFF

GSM to application OK command valid

Application to GSM AT&D2 Upon DTR switch from on to OFF, the call is

cleardown

GSM to application OK command valid

7.12. Set DSR signal &S

This commands controls the Data Set Ready (DSR) signal.

Application to GSM AT&S0 DSR always on

GSM to application OK command valid

Application to GSM AT&S1 DSR off in command mode, DSR on in data

mode

GSM to application OK command valid

7.13. Save configuration &W

This commands writes the active configuration to nonvolatile RAM.

Application to GSM AT&W writes current configuration to E2prom

GSM to application OK command valid

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 66 67

Sin comentarios

Wavecom G900 Manual de usuario Pagina 49